Nissan 2009 Armada Bedienungsanleitung PDF herunterladen (Seite 23)

HOMELINK姞 UNIVERSAL TRANSCEIVER (if so equipped)

SYSTEM OPERATING TIPS

䡲 Garage doors, electrical gates, entry doors, etc. will be activated during programming.

To avoid injury, make sure that people and objects are clear of all doors or gates during

programming. Your vehicle’s engine should be turned off while programming the

HomeLink姞 Transceiver.

䡲 To program your HomeLink姞 Transceiver to operate a garage door, gate, or entry door

opener, home or office lighting, you need to be at the same location as the device.

NOTE: Garage door openers (manufactured after 1996) have “rolling code pro-

tection”. To program a garage door opener equipped with “rolling code protec-

tion”, you will need to use a ladder to get up to the garage door opener motor to

be able to access the “smart or learn” program button.

PROGRAMMING YOUR HOMELINK姞 UNIVERSAL TRANSCEIVER (Mirror,

Sun Visor or Overhead Console)

1. To begin, press and hold the

two outer HomeLink姞 buttons

(to clear the memory) until the

indicator light blinks slowly (af-

ter 20 seconds). Release both

buttons.

2. Position the end of the hand-

held transmitter 1-3 inches (26-

76 mm) away from the

HomeLink姞 surface.

3. Using both hands, simultaneously press and hold both the HomeLink姞 button you

want to program and the hand-held transmitter button. DO NOT release the

buttons until step 4 has been completed.

4. Hold down both buttons until the indicator light on the HomeLink姞 flashes, changing

from a “slow blink” to a “rapidly flashing blink”. This could take up to 90 seconds.

When the indicator light flashes rapidly, both buttons may be released. The rapidly

flashing light indicates successful programming. To activate the garage door or other

programmed device, press and hold the programmed HomeLink姞 button - releasing

when the device begins to activate.

5. If the indicator light on the HomeLink姞 blinks rapidly for two seconds and then turns

solid, HomeLink姞 has picked up a “rolling code” garage door opener signal. You will

need to proceed with the next steps to train the HomeLink姞 to complete the

programming which may require a ladder and another person for convenience.

6. Press and release the “smart” or “learn” program button located on the garage door

opener’s motor to activate the “training mode”. This button is usually located near the

antenna wire that hangs down from the motor. If the wire originates from under a light

lens, you will need to remove the lens to access the program button.

NOTE: Once you have pressed and released the program button on the garage

door opener’s motor and the “training light” is lit, you have 30 seconds in which

to perform step 7. Use the help of a second person for convenience to assist when

performing this step.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Nissan 2009 Armada Bedienungsanleitung Seite 23

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Nissan 2009 Armada