
iPod姞* PLAYER OPERATION
WITHOUT NAVIGATION SYSTEM (if
so equipped)
Connecting iPod姞
To connect an iPod姞 to the vehicle so that the
iPod姞 can be controlled with the audio system
controls and display screen, use the USB jack
located in the center console. Connect the
iPod姞-specific end of the cable to the iPod姞 and
the USB end of the cable to the USB jack on the
vehicle
䊊
1
. If your iPod姞 supports charging via a
USB connection, its battery will be charged while
connected to the vehicle with the ignition switch
in the ACC or ON position.
While connected to the vehicle, the iPod姞 can
only be operated by the vehicle audio controls.
To disconnect the iPod姞 from the vehicle, remove
the USB end of the cable from the USB jack on
the vehicle, then remove the cable from the
iPod姞.
*iPod姞 is a trademark of Apple Inc., registered in
the U.S. and other countries.
Compatibility
The following models are compatible:
● iPod姞 5th Generation - version 1.2.1
● iPod姞 Classic - version 1.1
● iPod姞 Touch - version 2.1.0
● iPod姞 Nano - 1st generation version 1.3.1
● iPod姞 Nano - 2nd generation version 1.1.3
● iPod姞 Nano - 3rd generation version 1.0.2
Make sure that your iPod姞 firmware is updated to
the version indicated above.
Audio main operation
Place the ignition switch in the ACC or ON
position. Press the AUX button repeatedly to
switch to the iPod姞 mode.
If the system has been turned off while the iPod姞
was playing, pressing the VOL/ON·OFF control
knob will start the iPod姞.
AUX button:
When the AUX button is pressed with the system
off and the iPod姞 connected, the system will turn
on. If another audio source is playing and the
iPod姞 is connected, press the AUX button re-
peatedly until the center display changes to the
iPod姞 mode.
LHA2030 LHA1395
4-92 Monitor, climate, audio, phone and voice recognition systems
Kommentare zu diesen Handbüchern