Nissan 2013 Murano - Owner's Manual Bedienungsanleitung PDF herunterladen (Seite 366)

Black plate (364,1)

[ Edit: 2012/ 7/ 31 Model: Z51-D ]

5-18 Starting and driving

SSD0692

Overdrive (O/D) OFF switch

GUID-8A3D61C2-25A C-4088-A419-A1EAB3D4657F

When the O/D OFF switch is pushed with the

selector lever in the D (Drive) position, the

indicator light in the instrument panel illuminates.

Use the overdrive off mode when you need

improved engine braking.

To turn off the overdrive off mode, push the O/D

OFF switch again. The

indicator light will

turn off.

Each time the engine is started, or when the

selector lever is shifted to any position other

than the D (Drive) position, the overdrive off

mode will be automatically turned off.

Accelerator downshift — In D position —

GUID-CD19E66D-4772-4785-B00D-BC9BC6AC4E04

For passing or hill climbing, fully depress the

accelerator pedal to the floor. This shifts the

transmission down into a lower gear, depending

on the vehicle speed.

High fluid temperature protection mode

GUID-FE0DB0A0-F4AF-44F6-8609-E1599FEA814D

This transmission has a high fluid temperature

protection mode. If the fluid temperature be-

comes too high (for example, when climbing

steep grades in high temperature with heavy

loads, such as when towing a trailer), engine

power and, under some conditions, vehicle

speed will be decreased automatically to reduce

the chance of transmission damage. Vehicle

speed can be controlled with the accelerator

pedal, but the engine and vehicle speed may be

limited.

Fail-safe

GUID-CA9C7C97-9363-4621-960F-9DED536408A1

If the vehicle is driven under extreme

conditions, such as excessive wheel spin-

ning and subsequent hard braking, the

fail-safe system may be activated. The MIL

may illuminate to indicate the fail-safe

mode is activated. (See “Malfunction In-

dicator Light (MIL)” in the “2. Instruments

and controls” section.) This will occur even

if all electrical circuits are functioning

properly. In this case, place the ignition

switch in the OFF position and wait for 10

seconds. Then place the ignition switch

back in the ON position. The vehicle should

return to its normal operating condition. If

it does not return to its normal operating

condition, have a NISSAN dealer check the

transmission and repair if necessary.

WARNING

When the high fluid temperature pro-

tection mode or fail-safe operation

occurs, vehicle speed may be gradually

reduced. The reduced speed may be

lower than other traffic, which could

increase the chance of a collision. Be

especially careful when driving. If ne-

cessary, pull to the side of the road at a

safe place and allow the transmission

to return to normal operation, or have it

repaired if necessary.

Condition:

1 2 ... 361 362 363 364 365 366 367 368 369 370 371 ... 506 507

Kommentare zu diesen Handbüchern

Keine Kommentare