Nissan 2014 Quest - Owner's Manual Bedienungsanleitung PDF herunterladen (Seite 140)

PROGRAMMING HomeLink

FOR CA-

NADIAN CUSTOMERS AND GATE

OPENERS

Canadian radio-frequency laws require trans-

mitter signals to “time-out” (or quit) after several

seconds of transmission – which may not be

long enough for HomeLink

to pick up the signal

during programming. Similar to this Canadian

law, some U.S. gate operators are designed to

“time-out” in the same manner.

If you live in Canada or you are having difficulties

programming a gate operator or garage door

opener by using the “Programming HomeLink

”

procedures, replace “Programming HomeLink

”

Step 2 with the following:

NOTE:

When programming a garage door opener,

etc., unplug the device during the “cycling”

process to prevent possible damage to the

garage door opener components.

Step 2: Using both hands, simultaneously press

and hold the desired HomeLink

button and the

hand-held transmitter button. During program-

ming, your hand-held transmitter may automati-

cally stop transmitting. Continue to press and

hold the desired HomeLink

button while you

press and re-press (“cycle”) your hand-held

transmitter every two seconds until the fre-

quency signal has been learned. The HomeLink

indicator light will flash slowly and then rapidly

after several seconds upon successful program-

ming. DO NOT release until the HomeLink

indicator light flashes slowly and then rapidly.

When the indicator light flashes rapidly, both

buttons may be released. The rapid flashing

indicates successful programming.

Proceed with “Programming HomeLink

” step 3

to complete.

Remember to plug the device back in when

programming is completed.

OPERATING THE HomeLink

UNIVER-

SAL TRANSCEIVER

The HomeLink

Universal Transceiver, after it is

programmed, can be used to activate the

programmed device. To operate, simply press

and release the appropriate programmed

HomeLink

Universal Transceiver button. The

amber indicator light will illuminate while the

signal is being transmitted.

For convenience, the hand-held transmitter of

the device may also be used at any time.

PROGRAMMING TROUBLESHOOT-

ING

If the HomeLink

does not quickly learn the

hand-held transmitter information:

. replace the hand-held transmitter batteries

with new batteries.

. position the hand-held transmitter with its

battery area facing away from the

HomeLink

surface.

. press and hold both the HomeLink

and

hand-held transmitter buttons without inter-

ruption.

. position the hand-held transmitter 1-3 in

(26-76 mm) away from the HomeLink

surface. Hold the transmitter in that position

for up to 15 seconds. If HomeLink

is not

programmed within that time, try holding the

transmitter in another position - keeping the

indicator light in view at all times.

If you have any questions or are having difficulty

programming your HomeLink

buttons, refer to

the HomeLink

web site at: www.homelink.com

or 1-800-355-3515.

Instruments and controls 2-61

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 481 482

Kommentare zu diesen Handbüchern

Keine Kommentare

Nissan 2014 Quest - Owner's Manual Bedienungsanleitung Seite 140

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Nissan 2014 Quest - Owner's Manual